Prusa3D Forum

Notifications

Clear all

Dork1522

Groupe: Enregistré

A(ont) rejoint: 2021/05/19

Active Member

	@tim-2@cwbulletFor anyone with the same issue ... I spoke wi... Dans le forum General discussion, announcements and releases	il y a 4 years
	Will do. Thank you and everyone for your efforts and assist... Dans le forum General discussion, announcements and releases	il y a 4 years
	@joantabb I'm sure that is possible as I am the LEAST techni... Dans le forum General discussion, announcements and releases	il y a 4 years
	@cwbullet No. I have 0 on the hotend and 23 on the bed with... Dans le forum General discussion, announcements and releases	il y a 4 years
	@diem Thanks. I do not have a multimeter. But swapping the... Dans le forum General discussion, announcements and releases	il y a 4 years
	@tim-2 Thanks. I did as you suggested. The nozzle temp rea... Dans le forum General discussion, announcements and releases	il y a 4 years
	@baklin The ICD temp reads ZERO. I had assumed that meant t... Dans le forum General discussion, announcements and releases	il y a 4 years
	@diem I have read that. Thanks. The room is about 70F. So... Dans le forum General discussion, announcements and releases	il y a 4 years
	"mintemp" Error - Please Help Dans le forum General discussion, announcements and releases	il y a 4 years

Statistiques du forum

565 Forums

63.9 K Sujets

447.6 K Messages

19 En-ligne

69.5 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé