Prusa3D Forum

Notifications

Clear all

Domo890

Groupe: Enregistré

A(ont) rejoint: 2017/10/17

Active Member

	Hello Joan, I first had the issue on the previous firmware... Dans le forum Others (Archive)	il y a 8 years
	Hot End Switch Off Dans le forum Others (Archive)	il y a 8 years
	I had this for a while... The issue for me was that the prin... Dans le forum Others (Archive)	il y a 8 years
	Yes after looking last night I had created a new one from th... Dans le forum Others (Archive)	il y a 8 years
	I had trouble in sli3er on my old printer and now am use to ... Dans le forum Others (Archive)	il y a 8 years
	Thanks hiElvis i have a mechanical background so this side ... Dans le forum Others (Archive)	il y a 8 years
	R Pi Monitor Dans le forum Others (Archive)	il y a 8 years
	Hi, My understanding is when the valve is at 1 the end sto... Dans le forum Others (Archive)	il y a 8 years
	I still believe the quality is amazing. just look at this 20... Dans le forum Others (Archive)	il y a 8 years
	I have to agree, I have had my up and running since Thursday... Dans le forum Others (Archive)	il y a 8 years
	Received mine today! Cant wait to get started. I want to sa... Dans le forum General discussion, announcements and releases	il y a 8 years
	I think moisture might be a bigger issue for you if it's in ... Dans le forum Others (Archive)	il y a 8 years
	I can confirm (sorry for cross posting) that PLA / PETG clog... Dans le forum Others (Archive)	il y a 8 years
	My heated enclosure reads about 42C near the top and roughly... Dans le forum Others (Archive)	il y a 8 years
	Thanks @kai.r3, i dont really know about the electronics sid... Dans le forum Others (Archive)	il y a 8 years
	Great thank you. This is something to think about, which par... Dans le forum Others (Archive)	il y a 8 years
	I am not sure yet, I wanted to experiment with it to see wha... Dans le forum Others (Archive)	il y a 8 years
	Enclosure with the ambient sensor Dans le forum Others (Archive)	il y a 8 years

Statistiques du forum

585 Forums

68.2 K Sujets

478 K Messages

13 En-ligne

76 K Membres

Le dernier des messages: Immediately severely clogged after only 2 test prints Notre nouveau membre: ArtiVIVO Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé