Prusa3D Forum

Notifications

Clear all

dominick.m

Groupe: Enregistré

A(ont) rejoint: 2016/10/06

Eminent Member

	Here is a video of the jam as it is happening. I thought I ... Dans le forum Others (Archive)	il y a 9 years
	What temperature are you printing at? Are you using Z-Lift?... Dans le forum Others (Archive)	il y a 9 years
	Ok, I rebuilt everything, and now my problem is actually pre... Dans le forum Others (Archive)	il y a 9 years
	It looks good, except for the intense stringing of course. ... Dans le forum Others (Archive)	il y a 9 years
	We'll see. I finally got a response from someone at PR last... Dans le forum Others (Archive)	il y a 9 years
	Sorry to hear about your nozzle, that could be tricky to get... Dans le forum Others (Archive)	il y a 9 years
	I may have tried running them tighter at one point, but I ca... Dans le forum Others (Archive)	il y a 9 years
	Looks much like my problem, see I think in my case it was ... Dans le forum Others (Archive)	il y a 9 years
	I'm still having this same issue. Since the last time I've ... Dans le forum Others (Archive)	il y a 9 years
	I live in the desert. It was probably a difference of two d... Dans le forum Others (Archive)	il y a 9 years
	What temp are you printing with? Have you tried printing a ... Dans le forum Others (Archive)	il y a 9 years
	Extrusion Problem Dans le forum Others (Archive)	il y a 9 years
	Where to buy hot end thermistor? Dans le forum Others (Archive)	il y a 9 years
	That didn't clear up the issue. I'm still having problems. ... Dans le forum Ostatní (Archiv)	il y a 9 years
	I have done a few prints with simplify3D and it seems to und... Dans le forum Others (Archive)	il y a 9 years
	Patrik, I agree that it might be skipped steps on the prusa ... Dans le forum Ostatní (Archiv)	il y a 9 years
	Both fans are functional, it's still underextruding. Edit: ... Dans le forum Ostatní (Archiv)	il y a 9 years
	It is PLA. I'll check tonight to see if those are both runn... Dans le forum Ostatní (Archiv)	il y a 9 years
	Re: Problem with extruder thermistor. Dans le forum Ostatní (Archiv)	il y a 9 years
	Nevermind. I'm having under-extrusion problems now. It loo... Dans le forum Ostatní (Archiv)	il y a 9 years

Page 1 / 2 Suivant

Statistiques du forum

585 Forums

68.2 K Sujets

477.9 K Messages

10 En-ligne

75.9 K Membres

Le dernier des messages: Print head strangely shifted right Notre nouveau membre: ArtiVIVO Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé