DJ – Activité – Prusa3D Forum

Notifications

Clear all

Groupe: Enregistré

A(ont) rejoint: 2017/04/29

Trusted Member

	Michigan humidity? ha. ha. ha. Our average humidity over a ... Dans le forum General discussion, announcements and releases	il y a 7 years
	I real hoot. Thanks for the first look at the new attachmen... Dans le forum Others (Archive)	il y a 7 years
	TL;DR: Is there a way to stop my MK3 from doing bed leveling... Dans le forum Others (Archive)	il y a 7 years
	....but doesn't take in account of the bed warping as result... Dans le forum Hardware, firmware and software help	il y a 7 years
	I'm also in a very cold, dry climate. I usually touch the m... Dans le forum Others (Archive)	il y a 7 years
	Not to mention the need for connectors that won't fail due t... Dans le forum Others (Archive)	il y a 7 years
	if only they could implement petg first layer calibration. ... Dans le forum Others (Archive)	il y a 7 years
	Hi Paul. Have a look here: DJ Dans le forum Others (Archive)	il y a 7 years
	Re: Delays over delays for the MK3 - I'm fed up, cancelled m... Dans le forum Others (Archive)	il y a 7 years
	From your last picture it appears that the gear is slightly ... Dans le forum Others (Archive)	il y a 7 years
	Does this mean that the filament turns the wheel by friction... Dans le forum Improvements (Archive)	il y a 7 years
	Would this new mechanism properly detect slipping of the [ja... Dans le forum Improvements (Archive)	il y a 7 years
	I've had various issues with what I might best call "intermi... Dans le forum Others (Archive)	il y a 7 years

Page 4 / 4 Précédent

Statistiques du forum

559 Forums

63 K Sujets

443.2 K Messages

20 En-ligne

67.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé