Prusa3D Forum

Notifications

Clear all

dinots

Skupina: Registrovaný

Přidal se: 2019/07/31

Active Member

	Wow, thanks for the reply. This frustrated me to no end. T... In forum Hardware, firmware and software help	před 5 years
	I made no adjustments. I had already lubricated the heck ou... In forum Hardware, firmware and software help	před 5 years
	The Prusa articles says anything above 240 is ok. Does this ... In forum Hardware, firmware and software help	před 5 years
	I have oiled all the bearings using Super Lube, as recommend... In forum Hardware, firmware and software help	před 5 years
	I did. I actually followed on of the recommendations of a b... In forum Hardware, firmware and software help	před 5 years
	This is beyond frustrating... So, my printer was functioning... In forum Hardware, firmware and software help	před 5 years

Fórum Statistiky

559 Fóra

62.7 K Témata

442.2 K Příspěvky

19 Online

67.3 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed