|
vertigo grey is sort of an exception, that filament is top n... Dans le forum Others (Archive) |
il y a 7 years |
|
On my MK2s on the latest firmware for that printer i found t... Dans le forum Others (Archive) |
il y a 7 years |
|
the real problem is the price. we need an open source one... Dans le forum Others (Archive) |
il y a 7 years |
|
I did not used any additional settings in slicer.
How acc... Dans le forum Others (Archive) |
il y a 7 years |
|
Lets wait until end of FEB, then we start nagging them.
Im r... Dans le forum Others (Archive) |
il y a 7 years |
|
I'm new to this, what would be the reasons for using a gloss... Dans le forum Others (Archive) |
il y a 7 years |
|
probably delayed. Dans le forum Others (Archive) |
il y a 7 years |
|
Yeah, i understand what you mean: first i should replace the... Dans le forum Others (Archive) |
il y a 7 years |
|
Prusa just released a new Heatbed Cable Cover for the MK3/MK... Dans le forum Others (Archive) |
il y a 7 years |
|
Yes, I understand that. I guess I was expecting there to be ... Dans le forum Others (Archive) |
il y a 7 years |
|
could be, but check the bed screws too, it will vibrate like... Dans le forum Others (Archive) |
il y a 7 years |
|
it's probably warped, just put a straight edge (ruler will w... Dans le forum Others (Archive) |
il y a 7 years |
|
Another question for you all does anybody know why others ha... Dans le forum Improvements (Archive) |
il y a 7 years |
|
I would think it would be impossible to line up on any print... Dans le forum Others (Archive) |
il y a 7 years |
|
I found the igus with the metal casing for Y don't line up ... Dans le forum Others (Archive) |
il y a 7 years |
|
...
I will be building a chamber for it (since I'm not using... Dans le forum Others (Archive) |
il y a 7 years |
|
Jesus, this is disappointing.... i guess it wasn't tested on... Dans le forum Others (Archive) |
il y a 7 years |
|
1. Something to clean the nozzle, even after filament change... Dans le forum General discussion, announcements and releases |
il y a 7 years |
|
So as promised I did some measurements:
For all 100 mm set
A... Dans le forum Prusa i3 kit (Archive) |
il y a 7 years |
|
This problem is a year+ old and should of been fixed in mk2s... Dans le forum Prusa i3 kit (Archive) |
il y a 7 years |
