Notifications
Clear all
dibor
Group: Registered
Joined: 2022/04/25
Active Member
1
| @Balazs Tnx for the answer 🙂 Best Wishes. | 2 years ago | |
| Hello.Compatible with Bondtech extruder ?Possible to change ... | 2 years ago | |
| Thank U for explanation! | 3 years ago | |
| Relevant's of extrusion mult. settings. | 3 years ago | |
|
Hello.Thank you for the update. I cannot to check it because... In forum PrusaSlicer |
3 years ago | |
| Hello to the Team. Why needs to heat bed while load/unload f... | 3 years ago | |
|
Error occurred only with few models on the table.
With one... In forum PrusaSlicer |
3 years ago | |
|
Hi. I have a trouble with bundle.After slicing and sending g... In forum PrusaSlicer |
3 years ago | |
| Thank U for this link. Now is absolutely clear. | 4 years ago | |
| This is not right, USB2 can supply 1000mA (1A) per port! But... | 4 years ago | |
| I need to know current from Prusa Mini+ board. Not from wiki... | 4 years ago | |
| What max output current on USB? | 4 years ago | |
| Hello. I'd like to see in the new firmware cooler speed in t... | 4 years ago |