|
The PINDA on MK2(S) has a known problem, the sensitivity dri... In forum Hardware, firmware and software help |
6 years ago |
|
No!
You need the firmware to know your new bed. The same go... In forum General discussion, announcements and releases |
6 years ago |
|
Because Prusa won't fix it, I will 😀 .
I have forked thei... In forum Others (Archive) |
6 years ago |
|
As a side note, there is no laser in a headlight !
So what ... In forum Others (Archive) |
6 years ago |
|
To see the parts in Prusa store you must be logged in !
If ... In forum Others (Archive) |
6 years ago |
|
I can confirm that the heat from the hotend can affect the P... In forum Others (Archive) |
6 years ago |
|
Pronterface has all the controls, just the interface it coun... In forum Hardware, firmware and software help |
6 years ago |
|
MK2 printers (even the MK2.5) are 12V, while the MK3 is 24V. In forum Others (Archive) |
6 years ago |
|
The plastic type you use depends on what you want to do with... In forum Others (Archive) |
6 years ago |
|
Fix MK2 PINDA In forum Others (Archive) |
6 years ago |
|
smaller nozzles will give you more details but tend to get c... In forum Others (Archive) |
6 years ago |
|
This recently happen to me, but I was using ABS.
Parts are ... In forum Others (Archive) |
6 years ago |
|
I did just that, replaced the old PINDA v1 with the new PIND... In forum Others (Archive) |
6 years ago |
|
random reboots while heating might be a failing power supply... In forum Others (Archive) |
6 years ago |
|
You might find UHU HART KUNST STOFF in your area, especially... In forum Print tips (Archive) |
6 years ago |
|
I think you should wait for the MK2.5 manual to appear, ther... In forum Prusa i3 kit (Archive) |
6 years ago |
|
Any updates on this ?
I've ordered a PINDA v2 probe as I am... In forum Software (Archive) |
6 years ago |
