|
A replacement nozzle arrived today (and an adapter) and I in... En el foro Hardware, firmware and software help |
hace 2 years |
|
You are printing wool threads. 😋
The test print for the d... En el foro Hardware, firmware and software help |
hace 2 years |
|
That may not be enough, try actively drying.
Last week was... En el foro Hardware, firmware and software help |
hace 2 years |
|
I allready fastened all screws when I fixed the belt tension... En el foro Hardware, firmware and software help |
hace 2 years |
|
After understanding the problem with Arachne, I have now eve... En el foro Hardware, firmware and software help |
hace 2 years |
|
I searched the forum for similar problems. Could this be the... En el foro Hardware, firmware and software help |
hace 2 years |
|
Ok. I tried an old gcode file with the filament that worked ... En el foro Hardware, firmware and software help |
hace 2 years |
|
Unfortunately the belts weren't the problem. Both were about... En el foro Hardware, firmware and software help |
hace 2 years |
|
The first layer is perfect (in most cases). 😉 I cleaned the... En el foro Hardware, firmware and software help |
hace 2 years |
|
@Diem: Yes, you are right. That's why I keep my filament in ... En el foro Hardware, firmware and software help |
hace 2 years |
|
Vertical delamination En el foro Hardware, firmware and software help |
hace 2 years |
|
Ok, here is the project file. TW39_lang_Löcher_offen En el foro PrusaSlicer |
hace 2 years |
|
Missing chunks in the Support Interface En el foro PrusaSlicer |
hace 2 years |
