Notifications
Clear all
Denesius
Group: Registered
Joined: 2025/05/07
Active Member
1
|
PrusaSlicer 2.9.4 with XL - selecting default extruder for a... In forum Prusa Connect & PrusaLink |
3 weeks ago | |
| Cute! To every problem, there's always a clever answer out t... | 4 months ago | |
| Good point - there may be other connections (to the componen... | 4 months ago | |
| Here we go..... | 4 months ago | |
| Good info - you do have one area where you can cut the trace... | 4 months ago | |
| So if anyone is interested, I ran a serial scanner on the GP... | 4 months ago | |
|
Was looking for a similar setup and came across this post. I... In forum Hardware, firmware and software help |
4 months ago | |
| Direct addressing of GPIO board | 4 months ago | |
|
I have the same issue with 2.9.2 - since I can't custom sele... In forum PrusaSlicer |
1 year ago |