Prusa3D Forum

Benachrichtigungen

Alles löschen

deckar01

Gruppe: Registriert

Beigetreten: 2017/08/09

Active Member

	Thank you for sharing this! I have been tending to a batch o... Im Forum General discussion, announcements and releases	Vor 1 year
	I redeemed my voucher about 4 hours after the email was rece... Im Forum General discussion, announcements and releases	Vor 6 years
	@andre.l9 has an interesting post about adjusting the filame... Im Forum Assembly and first prints troubleshooting	Vor 7 years
	I reduced the width of my bed to 240mm in Slic3r and the pri... Im Forum Hardware, firmware and software help	Vor 7 years
	I added a 3mm extension to the X axis end stop. The extruder... Im Forum Hardware, firmware and software help	Vor 7 years
	Stop Print Crashed into Purge Block Im Forum Hardware, firmware and software help	Vor 7 years
	The preset that came with my drivers was causing lots of war... Im Forum Print tips (Archive)	Vor 8 years
	I would rather take my next holiday in Prague than pay $62US... Im Forum Others (Archive)	Vor 8 years

Forums-Statistiken

585 Foren

68 K Themen

476.2 K Beiträge

9 Online

75.6 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen