Notifications
Clear all
deckar01
Grupa: Zarejestrowany
Dołączył: 2017/08/09
Active Member
1
| Thank you for sharing this! I have been tending to a batch o... | 1 year temu | |
| I redeemed my voucher about 4 hours after the email was rece... | 7 years temu | |
| @andre.l9 has an interesting post about adjusting the filame... | 7 years temu | |
|
I reduced the width of my bed to 240mm in Slic3r and the pri... In forum Hardware, firmware and software help |
7 years temu | |
|
I added a 3mm extension to the X axis end stop. The extruder... In forum Hardware, firmware and software help |
7 years temu | |
|
Stop Print Crashed into Purge Block In forum Hardware, firmware and software help |
7 years temu | |
|
The preset that came with my drivers was causing lots of war... In forum Print tips (Archive) |
8 years temu | |
|
I would rather take my next holiday in Prague than pay $62US... In forum Others (Archive) |
8 years temu |