Prusa3D Forum

Notifications

Clear all

deckar01

Group: Registered

Joined: 2017/08/09

Active Member

	Thank you for sharing this! I have been tending to a batch o... In forum General discussion, announcements and releases	7 months ago
	I redeemed my voucher about 4 hours after the email was rece... In forum General discussion, announcements and releases	6 years ago
	@andre.l9 has an interesting post about adjusting the filame... In forum Assembly and first prints troubleshooting	6 years ago
	I reduced the width of my bed to 240mm in Slic3r and the pri... In forum Hardware, firmware and software help	6 years ago
	I added a 3mm extension to the X axis end stop. The extruder... In forum Hardware, firmware and software help	6 years ago
	Stop Print Crashed into Purge Block In forum Hardware, firmware and software help	6 years ago
	The preset that came with my drivers was causing lots of war... In forum Print tips (Archive)	7 years ago
	I would rather take my next holiday in Prague than pay $62US... In forum Others (Archive)	7 years ago

Forum Statistics

565 Forums

63.8 K Topics

447.1 K Posts

19 Online

69.2 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed