Notifications
Clear all
david.z
Groupe: Enregistré
A(ont) rejoint: 2016/05/25
Eminent Member
2
|
David
That should be OK. Are you angling the end of the fi... Dans le forum Others (Archive) |
il y a 9 years | |
|
David
My guess is that the PTFE tube is not quite square at... Dans le forum Others (Archive) |
il y a 9 years | |
|
Thanks, PJR, for that procedure. I had been trying to do som... Dans le forum Others (Archive) |
il y a 9 years | |
|
Shree, PJR,
I heated up the nozzle/heat block/heatbreak ass... Dans le forum Others (Archive) |
il y a 9 years | |
|
I spoke with Dan from Prusa Research support. After showing ... Dans le forum Others (Archive) |
il y a 9 years | |
|
I'm curious, why does the calibration probe need to hit spec... Dans le forum Others (Archive) |
il y a 9 years | |
|
Most users have ended up having to displantly the extruder,
... Dans le forum Others (Archive) |
il y a 9 years | |
|
No leaks anywhere. A little bit of plastic was weakly coming... Dans le forum Others (Archive) |
il y a 9 years | |
|
Extruder completely stuck, heat didn't fix it Dans le forum Others (Archive) |
il y a 9 years |
Page 2 / 2
Précédent