Notifications
Clear all
david.s30
david.s30
Grupa: Zarejestrowany
Dołączył: 2017/01/02
Active Member
1
I had a file in S3d that I used the "Seperated Connected Sur...

In forum Others (Archive)

7 years temu
What about WD40 Specialist Protective White Lithium Grease. ...

In forum Others (Archive)

7 years temu
NP, theres plenty to print in between forums replies. 🙂 I...

In forum Software (Archive)

8 years temu
I installed it today and will try some test prints with KISS...

In forum Software (Archive)

8 years temu
Cura 2.4.0

In forum Software (Archive)

8 years temu
Hi David. You linked to a thingyverse page instead of some g...

In forum Hardware, firmware and software help

8 years temu
ABS

In forum Others (Archive)

8 years temu
Sorry for not responding sooner. I haven't had any issues wi...

In forum Hardware, firmware and software help

8 years temu
I spoke through email to one of the Misumi engineers and he ...

In forum Others (Archive)

8 years temu
I would check to see if you have it level. Get a cheap level...

In forum Others (Archive)

8 years temu
Yes, I built my printer and have been testing it for about t...

In forum Hardware, firmware and software help

8 years temu
After a long email conversation with an Engineer at Misumi, ...

In forum Hardware, firmware and software help

8 years temu
Also can you confirm the lengths? Thanks Smallest smooth r...

In forum Hardware, firmware and software help

8 years temu
I had the PSFU8- rods and the LMU-N8 in the cart, then I spo...

In forum Hardware, firmware and software help

8 years temu
I wanted to update my X,Y,Z-axis rods lengths to achieve qui...

In forum Hardware, firmware and software help

8 years temu
I wanted to update my X,Y,Z-axis rods lengths to achieve qui...

In forum Prusa i3 kit (Archive)

8 years temu
Share: