Čeština
Fóra
Uživatelé
david.m3
Aktivita
 
Notifications
Clear all
david.m3
david.m3
Skupina: Registrovaný
Přidal se: 2015/11/27
Eminent Member
2
Profile Aktivita
Thanks Peter I'm now sorted. I wasn't sure how long it was...

In forum Prusa i3 kit (Archive)

 před 9 years
My MkII was printing just fine, then I unloaded some ABS fil...

In forum Prusa i3 kit (Archive)

 před 9 years
Thanks 😀 Change the machine size in Cura because the Mk2...

In forum Others (Archive)

 před 9 years
I'm using Hatchbox ABS - now working fine with the adjustmen...

In forum Others (Archive)

 před 9 years
Thanks 😀 I've just upgrade my Mk1 to Mk2 and initial res...

In forum Others (Archive)

 před 9 years
Nine point auto bed leveling enable/disable in gcode

In forum Others (Archive)

 před 9 years
Recommended print speeds

In forum Others (Archive)

 před 9 years
I've now managed to fix this problem. When fitting the PIND...

In forum Assembly and first prints troubleshooting

 před 9 years
OK, so I've just looked in the source code to try to find ou...

In forum Assembly and first prints troubleshooting

 před 9 years
So, with the printer powered off, I use a digital caliper be...

In forum Assembly and first prints troubleshooting

 před 9 years
Nearly! The right hand side is just less than 1mm higher th...

In forum Assembly and first prints troubleshooting

 před 9 years
But the error message specifies that it's a X/Z axis problem...

In forum Assembly and first prints troubleshooting

 před 9 years
[SOLVED] X/Z skewed severly

In forum Assembly and first prints troubleshooting

 před 9 years
I also had difficulties levelling the bed. On mine, two opp...

In forum Prusa i3 kit (Archive)

 před 10 years
Thanks for the ABS fan tip. My temperature dropping problem...

In forum Prusa i3 kit (Archive)

 před 10 years
I have checked and can confirm that the connectors are prope...

In forum Prusa i3 kit (Archive)

 před 10 years
I too have this problem. I've not long had my i3. It was w...

In forum Prusa i3 kit (Archive)

 před 10 years
In case anyone else finds this thread because they have a si...

In forum Print tips (Archive)

 před 10 years
You guess incorrectly Peter - that is NOT my reason for wish...

In forum Print tips (Archive)

 před 10 years
slic3r settings to print Marvin to join 3dHubs

In forum Print tips (Archive)

 před 10 years
Stránka 1 / 2
Share: