Notifications
Clear all
david.m3
david.m3
Group: Registered
Joined: 2015/11/27
Eminent Member
2
Thanks Peter I'm now sorted. I wasn't sure how long it was...

In forum Prusa i3 kit (Archive)

8 years ago
My MkII was printing just fine, then I unloaded some ABS fil...

In forum Prusa i3 kit (Archive)

8 years ago
Thanks 😀 Change the machine size in Cura because the Mk2...

In forum Others (Archive)

8 years ago
I'm using Hatchbox ABS - now working fine with the adjustmen...

In forum Others (Archive)

8 years ago
Thanks 😀 I've just upgrade my Mk1 to Mk2 and initial res...

In forum Others (Archive)

8 years ago
Nine point auto bed leveling enable/disable in gcode

In forum Others (Archive)

8 years ago
Recommended print speeds

In forum Others (Archive)

8 years ago
I've now managed to fix this problem. When fitting the PIND...

In forum Assembly and first prints troubleshooting

8 years ago
OK, so I've just looked in the source code to try to find ou...

In forum Assembly and first prints troubleshooting

8 years ago
So, with the printer powered off, I use a digital caliper be...

In forum Assembly and first prints troubleshooting

8 years ago
Nearly! The right hand side is just less than 1mm higher th...

In forum Assembly and first prints troubleshooting

8 years ago
But the error message specifies that it's a X/Z axis problem...

In forum Assembly and first prints troubleshooting

8 years ago
[SOLVED] X/Z skewed severly

In forum Assembly and first prints troubleshooting

8 years ago
I also had difficulties levelling the bed. On mine, two opp...

In forum Prusa i3 kit (Archive)

9 years ago
Thanks for the ABS fan tip. My temperature dropping problem...

In forum Prusa i3 kit (Archive)

9 years ago
I have checked and can confirm that the connectors are prope...

In forum Prusa i3 kit (Archive)

9 years ago
I too have this problem. I've not long had my i3. It was w...

In forum Prusa i3 kit (Archive)

9 years ago
In case anyone else finds this thread because they have a si...

In forum Print tips (Archive)

9 years ago
You guess incorrectly Peter - that is NOT my reason for wish...

In forum Print tips (Archive)

9 years ago
slic3r settings to print Marvin to join 3dHubs

In forum Print tips (Archive)

9 years ago
Page 1 / 2
Share: