Prusa3D Forum

Notifications

Clear all

david.m151

Grupa: Zarejestrowany

Dołączył: 2018/12/05

Active Member

	Thanks for the hint. I've just tried that and it got a bit b... In forum Hardware, firmware and software help	7 months temu
	MK3S+ bed temperature 10 degrees off In forum Hardware, firmware and software help	7 months temu
	I'm also looking for a way to do this. I've added a layer co... In forum How do I print this? (Printing help)	6 years temu
	I found a workarround for this problem in the meantime. I fo... In forum How do I print this? (Printing help)	6 years temu
	PrusaSlicer puts infill areas where a clean layer would be b... In forum How do I print this? (Printing help)	6 years temu
	I've just tested this. The high pitched noise stops at value... In forum Hardware, firmware and software help	6 years temu
	You can set the fan speed - even when not printing - with Co... In forum Hardware, firmware and software help	6 years temu
	What are you printing with? Is the part cooling fan running ... In forum Hardware, firmware and software help	6 years temu
	High pitched noise from part cooling fan In forum Hardware, firmware and software help	6 years temu

Statystyki Forum

565 Fora

63.8 K Tematy

447.2 K Posty

20 Online

69.3 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte