Notifications
Clear all
david.j49
david.j49
Skupina: Registrovaný
Přidal se: 2019/02/11
Eminent Member
2
Is dust (rust?) in nozzle thread normal?

In forum Hardware, firmware and software help

před 3 years
Hey guys, thanks for the tips. The problem pictured above w...

In forum How do I print this? (Printing help)

před 5 years
Does it look like this? I just had this happen for the fir...

In forum How do I print this? (Printing help)

před 5 years
Help needed with a tall thin object that has minimal contact...

In forum How do I print this? (Printing help)

před 5 years
Unlike images uploaded to this forum before the “upgrade?”

In forum How do I print this? (Printing help)

před 5 years
I wouldn't call that simple. I don't even know how to place...

In forum Hardware, firmware and software help

před 5 years
Layer height table in Prusa Slicer

In forum Hardware, firmware and software help

před 5 years
OK, rerunning XYZ calibration did fix the issue. Now my 0,0 ...

In forum Hardware, firmware and software help

před 5 years
OK, guys, I'm 100% with you on it being a software issue. I ...

In forum Hardware, firmware and software help

před 5 years
OK, here's the print. It's stitched together from two scans,...

In forum Hardware, firmware and software help

před 5 years
I'm getting no such warning, have you turned off the skirt? ...

In forum Hardware, firmware and software help

před 5 years
How's this (see attachment) for a full-bed linearity test? I...

In forum Hardware, firmware and software help

před 5 years
If calipers are enough, I can measure the belt. Just tell me...

In forum Hardware, firmware and software help

před 5 years
Actually quite the opposite — the cable bundle is causing a ...

In forum Hardware, firmware and software help

před 5 years
I'll give that a try. Unfortunately I don't have time for th...

In forum Hardware, firmware and software help

před 5 years
I thought so, too. There was a bit of twisting, so I pulled ...

In forum Hardware, firmware and software help

před 5 years
I looked at the pulley through a magnifying glass (40x) whil...

In forum Hardware, firmware and software help

před 5 years
tim-m30: I'm not sure what belt paths are, but here are all ...

In forum Hardware, firmware and software help

před 5 years
My bad. Attempt #2. Also update: I found the source of the ...

In forum Hardware, firmware and software help

před 5 years
I printed the squares on a textured sheet, so you won't be a...

In forum Hardware, firmware and software help

před 5 years
Stránka 1 / 2
Share: