|
Nice example of controlling RGB w/ I2C:
Simple bridge betw... In forum Others (Archive) |
7 years ago |
|
Cool, thanks for the info.
So are those the pin headers loc... In forum Others (Archive) |
7 years ago |
|
MK2 Rambo pin available for LED control w/ Gcode? In forum Others (Archive) |
7 years ago |
|
It would be cool if an option was available to print in quie... In forum Hardware, firmware and software help |
7 years ago |
|
Maybe the following will help:
- Slowing down the print.
- A... In forum Others (Archive) |
7 years ago |
|
I loaded a gcode file, but the model would not render using ... In forum Hardware, firmware and software help |
7 years ago |
|
I like how the is a icon that will let me rotate things with... In forum Hardware, firmware and software help |
7 years ago |
|
I really like the interface which is handy when you have to ... In forum Hardware, firmware and software help |
7 years ago |
|
Cura also supports this
Nice write up for Slic3r: In forum Others (Archive) |
7 years ago |
|
Surprisingly good heat properties of Prusa Black PLA. In forum Print tips (Archive) |
7 years ago |
|
In order to get another data point, have you considered usin... In forum Others (Archive) |
7 years ago |
|
By nubs, do you mean like the supports Meshmixer creates? In forum Print tips (Archive) |
7 years ago |
|
Looks like you did not enable support in the slicer options,... In forum Prusa i3 kit (Archive) |
7 years ago |
|
PE Slic3r: Support settings, why is the default at 43? In forum Print tips (Archive) |
7 years ago |
|
Good point. I was concerned that the drill bit may break of... In forum Prusa i3 kit (Archive) |
7 years ago |
|
PE slic3r settings to get best results for this part using .... In forum Print tips (Archive) |
8 years ago |
|
I think it may be a cost / complexity / time tested design i... In forum Improvements (Archive) |
8 years ago |
|
Y-Frame holes for upgrading MK2 to MK2S In forum Prusa i3 kit (Archive) |
8 years ago |
|
Most awesome PLA nickel finish tutorial In forum Print tips (Archive) |
8 years ago |
|
Also, did you following the recommended print speeds? In forum Print tips (Archive) |
8 years ago |
