DaveGadgeteer – Activité

Notifications

Clear all

DaveGadgeteer

Groupe: Enregistré

A(ont) rejoint: 2018/10/15

Eminent Member

	Thanks! I started my previous one with thanks, but an editin... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Evidently if you go lower than .15mm for the first layer it ... Dans le forum How do I print this? (Printing help)	il y a 5 years
	I want a thin layer near the bottom Dans le forum How do I print this? (Printing help)	il y a 5 years
	Thank you. I found the solution, which seems quite strange. ... Dans le forum PrusaSlicer	il y a 5 years
	I had this problem with PETG printing until I installed the ... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Slicer 2.2 provides no way to link filament to parts? Dans le forum PrusaSlicer	il y a 5 years
	Need more hardware help with debugging problems. Dans le forum General discussion, announcements and releases	il y a 5 years
	Found it by accident: Drag with two fingers touching. Dans le forum PrusaSlicer	il y a 5 years
	Is there really no way to control the slicer zoom with track... Dans le forum PrusaSlicer	il y a 5 years
	Possible to get nice supported surface in PETG? Dans le forum How do I print this? (Printing help)	il y a 5 years

Page 2 / 2 Précédent

Statistiques du forum

559 Forums

62.8 K Sujets

442.4 K Messages

20 En-ligne

67.4 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé