Notifications
Clear all
DaveGadgeteer
Group: Registered
Joined: 2018/10/15
Eminent Member
2
|
Thanks! I started my previous one with thanks, but an editin... In forum How do I print this? (Printing help) |
5 years ago | |
|
Evidently if you go lower than .15mm for the first layer it ... In forum How do I print this? (Printing help) |
5 years ago | |
|
I want a thin layer near the bottom In forum How do I print this? (Printing help) |
5 years ago | |
|
Thank you. I found the solution, which seems quite strange. ... In forum PrusaSlicer |
5 years ago | |
|
I had this problem with PETG printing until I installed the ... In forum How do I print this? (Printing help) |
5 years ago | |
|
Slicer 2.2 provides no way to link filament to parts? In forum PrusaSlicer |
5 years ago | |
| Need more hardware help with debugging problems. | 5 years ago | |
|
Found it by accident: Drag with two fingers touching. In forum PrusaSlicer |
5 years ago | |
|
Is there really no way to control the slicer zoom with track... In forum PrusaSlicer |
5 years ago | |
|
Possible to get nice supported surface in PETG? In forum How do I print this? (Printing help) |
5 years ago |
Page 2 / 2
Prev