Notifications
Clear all
DarthMuffin
Skupina: Registrovaný
Přidal se: 2017/05/04
Eminent Member
2
|
Try this.
Don't know if I have taken enough off, and it is ... In forum Improvements (Archive) |
před 8 years | |
|
I had a very similar problem. For me it turned out to be an... In forum Others (Archive) |
před 8 years | |
|
Neat idea! Wish I had thought of that when assembling. Eye... In forum Prusa i3 kit (Archive) |
před 8 years | |
|
I wasn't impressed with the bearings either, and ended up re... In forum Prusa i3 kit (Archive) |
před 8 years | |
|
I also had scratches and noise from a bearing after about a ... In forum Prusa i3 kit (Archive) |
před 8 years | |
|
I went with the relatively new Noctua 40x20mm fan for the he... In forum Improvements (Archive) |
před 8 years | |
|
john, care to share your ngen settings? I have some and wou... In forum Print tips (Archive) |
před 8 years | |
|
The new firmware hard codes the value to 161.3. It will rev... In forum Software (Archive) |
před 8 years | |
|
Intermittent Mintemp Bed errors, where to buy thermistor? In forum Others (Archive) |
před 8 years |
Stránka 3 / 3
Předchozí