Prusa3D Forum

Notifications

Clear all

daniel.p10

Skupina: Registrovaný

Přidal se: 2016/12/10

Active Member

	I believe I have resolved this issue. I tore the whole prin... In forum General discussion, announcements and releases	před 6 years
	Excessive Calibration In forum General discussion, announcements and releases	před 6 years
	Calibration and Tower Offset In forum Hardware, firmware and software help	před 6 years
	This was the problem, the yellow wire was pinched. Thank yo... In forum Assembly and first prints troubleshooting	před 7 years
	Print Fan Error In forum Assembly and first prints troubleshooting	před 7 years
	Issues with IR sensor while printing PVA In forum General discussion, announcements and releases	před 7 years

Fórum Statistiky

595 Fóra

69.1 K Témata

483.2 K Příspěvky

13 Online

78 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed