|
Maybe separating, or having clearer naming, for the MMU3 tog... In forum Assembly and first prints troubleshooting |
2 weeks ago |
|
Thanks for the reply! I think it did fix the issue. After se... In forum Assembly and first prints troubleshooting |
3 weeks ago |
|
Upgrade MK4S > Core One +: Hotend filament sensor not (reall... In forum Assembly and first prints troubleshooting |
3 weeks ago |
|
This was also the fix for my hotend fan RPM error calibratio... In forum Hardware, firmware and software help |
4 weeks ago |
|
Just an update to say that my MK4S ran totally fine for clos... In forum Hardware, firmware and software help |
7 months ago |
|
Any news on this one? Did you experiment with the V and Us v... In forum Hardware, firmware and software help |
8 months ago |
|
Hi again!So, the balls did make a huge difference, thank you... In forum Hardware, firmware and software help |
9 months ago |
|
Sounds good, I'll give it a try and post the result! In forum Hardware, firmware and software help |
10 months ago |
|
Will do, thanks! I'll make sure to post an update once it's ... In forum Hardware, firmware and software help |
10 months ago |
|
Thanks for the suggestion! I'll definitely give that a try. ... In forum Hardware, firmware and software help |
10 months ago |
|
Thanks very much JoanTabb. In the meantime I also added a yo... In forum Hardware, firmware and software help |
10 months ago |
|
There was supposed to be a video up there, trying here a sec... In forum Hardware, firmware and software help |
10 months ago |
|
Help with noise and vibration MK3S In forum Hardware, firmware and software help |
10 months ago |
