Notifications
Clear all
Dan mor 2
Skupina: Registrovaný
Přidal se: 2018/02/06
Active Member
1
|
ok
I increase the nozzle temperature to 220c and the printe... In forum Others (Archive) |
před 7 years | |
|
no, it is not the pulley slipping on the motor shaft I check... In forum Others (Archive) |
před 7 years | |
|
Did it do this at all on the first layer? not all the time... In forum Others (Archive) |
před 7 years | |
|
att is the video
I did 2 print before only
it is a new prin... In forum Others (Archive) |
před 7 years | |
|
problem with the Extruder motor In forum Others (Archive) |
před 7 years |