Prusa3D Forum

Notifications

Clear all

DamienB

Skupina: Registrovaný

Přidal se: 2020/05/31

Active Member

	X Belt back cover screw not tightening? In forum Hardware, firmware and software help	před 4 years
	Hey I recognise it will never be as smooth, but this is un... In forum How do I print this? (Printing help)	před 4 years
	Layer under supports not smooth, rest of print fine. In forum How do I print this? (Printing help)	před 4 years
	@wook Hey glad to hear you have it sorted. 😁 Make sure you d... In forum Assembly and first prints troubleshooting	před 4 years
	@evanhovorka I spray my plate with contact adhesive, like 3M... In forum Assembly and first prints troubleshooting	před 4 years
	Jonathan's suggestions are good. I find I give the plate a g... In forum Assembly and first prints troubleshooting	před 4 years
	Hey Your nozzle is most likely too low. When doing the first... In forum Assembly and first prints troubleshooting	před 4 years
	I've experienced this also some time back. It happens. But o... In forum Assembly and first prints troubleshooting	před 4 years

Fórum Statistiky

559 Fóra

62.8 K Témata

442.3 K Příspěvky

23 Online

67.4 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed