|
I don't have any drafts where the printer is, it's the corne... In forum Others (Archive) |
8 years ago |
|
To follow up, the print did actually finish and the only cha... In forum Others (Archive) |
8 years ago |
|
I'm using plain old windex, but I tried with liquid dish soa... In forum Others (Archive) |
8 years ago |
|
I'm at my wits end, I spent most of today trying to get it t... In forum Others (Archive) |
8 years ago |
|
Thanks guys, I found the fan setting in Slic3r moments after... In forum Others (Archive) |
8 years ago |
|
Print Issues (with picture) In forum Others (Archive) |
8 years ago |
|
Ok, I updated to the latest firmware, did a factory reset, a... In forum Others (Archive) |
8 years ago |
|
One other question since I haven't done this before, can you... In forum Others (Archive) |
8 years ago |
|
I'll update tonight and see what happens.
Where can I find ... In forum Others (Archive) |
8 years ago |
|
Any idea what $ range the repair kit will cost and how diffi... In forum Others (Archive) |
8 years ago |
|
Heated bed and some questions/issues In forum Others (Archive) |
8 years ago |
|
They should be, I followed the instructions, but I'll check ... In forum Others (Archive) |
8 years ago |
|
Thanks for the feedback everyone, I will make some changes f... In forum Others (Archive) |
8 years ago |
|
I don't think it was the spool holder, as I was watching it ... In forum Others (Archive) |
8 years ago |
|
What caused this? In forum Others (Archive) |
8 years ago |
|
Building the Extruder now and ran into a few issues. The Ext... In forum Others (Archive) |
8 years ago |
|
Ok, I'm currently printing 3Dbenchy and it seems to be worki... In forum Others (Archive) |
8 years ago |
|
Ok, so let's say I have the demo's printing well and want to... In forum Others (Archive) |
8 years ago |
|
Slic3r Settings for MK2 In forum Others (Archive) |
8 years ago |
