cyrille.p – Activité – Prusa3D Forum

Notifications

Clear all

cyrille.p

Groupe: Enregistré

A(ont) rejoint: 2016/08/30

Estimable Member

	Colorprint super hero masks Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years
	I do the same as Peter, I use craftware to view the Gcode. I... Dans le forum Hardware, firmware and software help	il y a 8 years
	I've got the same problem, you can try this: Dans le forum Print tips (Archive)	il y a 8 years
	Thanks for the tip, I tried with a hair dryer but without su... Dans le forum Others (Archive)	il y a 8 years
	Very nice. What CAD do you use ? Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years
	white marks when detaching ABS Dans le forum Others (Archive)	il y a 8 years
	Yes once the PEI is heated for a new print, it seems to stic... Dans le forum Others (Archive)	il y a 8 years
	I saw someone using successfully a glass on the mk2 on youtu... Dans le forum Others (Archive)	il y a 8 years
	Like stephen said, use brim and you don't have to use those ... Dans le forum Print tips (Archive)	il y a 8 years
	I always print something else at the same time for small par... Dans le forum Print tips (Archive)	il y a 8 years
	I did it 3 days ago. Tune the extruder to 295 degrees, and l... Dans le forum Others (Archive)	il y a 8 years
	I print most of the time with ABS. My answer is YES, it prin... Dans le forum Others (Archive)	il y a 8 years
	Nice thank you PJR and Aaron 😉 Dans le forum Print tips (Archive)	il y a 8 years
	Would you mind sharing your bed stl model please ? Dans le forum Print tips (Archive)	il y a 8 years
	Thank you PJR ! Dans le forum Print tips (Archive)	il y a 8 years
	Hi PJR. I'll give it a try, I had good results with the prev... Dans le forum Print tips (Archive)	il y a 8 years
	I print excusively in ABS. Depending on the colour I use and... Dans le forum Print tips (Archive)	il y a 8 years
	I also use it to have an estimated time and filament used (i... Dans le forum Software (Archive)	il y a 8 years
	This is a very powerful feature !! I love it. I didn't know ... Dans le forum Software (Archive)	il y a 8 years
	NEW Prusa control slicer Dans le forum Software (Archive)	il y a 8 years

Page 4 / 8 Précédent Suivant

Statistiques du forum

567 Forums

64.8 K Sujets

453.5 K Messages

19 En-ligne

71.6 K Membres

Le dernier des messages: Upgrade from 3.0 to 3.5 - Instruction Manual does not match parts - LCD support Notre nouveau membre: Sedacrivity Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé