Attività
 
Notifiche
Cancella tutti
cwbullet
cwbullet
Gruppo: PrusaLink-beta
Registrato: 2018/07/13
Titolo: Utenti
@area51 Same here.

Nel forum Hardware, firmware and software help

5 years fa
@crawlerin I have to admit that a cheap pair of nail clipper...

Nel forum General discussion, announcements and releases

5 years fa
@jsw PC Blend is a grea chocie too.

Nel forum General discussion, announcements and releases

5 years fa
No issue. I am glad to be of help. I have done it for doze...

Nel forum Assembly and first prints troubleshooting

5 years fa
The shroud is in ASA because if you print ABS with a PETG sh...

Nel forum General discussion, announcements and releases

5 years fa
@painkiller Thanks for explaining. The Blog post clearly st...

Nel forum Hardware, firmware and software help

5 years fa
If this is what I think it is, I change my answer - I have s...

Nel forum Hardware, firmware and software help

5 years fa
@locktec I did too. I am retiring from a military job in le...

Nel forum General discussion, announcements and releases

5 years fa
What is the difference in the V0.4 Sensor?

Nel forum Hardware, firmware and software help

5 years fa
No. I am not sure why either would cause this unless 4.21 c...

Nel forum Hardware, firmware and software help

5 years fa
@prusaprinters-profile Makes sense. Either way, I would not...

Nel forum Coronavirus (COVID-19)

5 years fa
Would this work?

Nel forum User mods - OctoPrint, enclosures, nozzles, ...

5 years fa
@not_dave I am interested to hear how well it works.

Nel forum General discussion, announcements and releases

5 years fa
It is not listed in the store. Contact support by chat. Th...

Nel forum Hardware, firmware and software help

5 years fa
PETG ok?

Nel forum Assembly and first prints troubleshooting

5 years fa
@jsw I will do a thorough review when mine arrives. Not shi...

Nel forum General discussion, announcements and releases

5 years fa
@prusaprinters-profile Is there an age limit - like masks ar...

Nel forum Coronavirus (COVID-19)

5 years fa
@prusaprinters-profile Hmm. Maybe I am misunderstanding. I...

Nel forum Coronavirus (COVID-19)

5 years fa
@educa My pads do not leave marks. Make sure yours are mark...

Nel forum General discussion, announcements and releases

5 years fa
@dougd Be very, very careful. I had this happen and almost ...

Nel forum Hardware, firmware and software help

5 years fa
Pagina 353 / 571
Condividi: