Prusa3D Forum

Notifications

Clear all

ctag

Grupa: Zarejestrowany

Dołączył: 2018/05/06

Active Member

	OK, I finally opened my eyes enough to take Peter's advice. ... In forum Hardware, firmware and software help	5 years temu
	I went back and really crunched down the layer height and tr... In forum Hardware, firmware and software help	5 years temu
	@peter-m26 Thanks Peter. The first layer height is a lot low... In forum Hardware, firmware and software help	5 years temu
	@peter-m26 Thank you for the suggestion. I double checked, i... In forum Hardware, firmware and software help	5 years temu
	Underextruding on PETG prints after using PLA In forum Hardware, firmware and software help	5 years temu

Statystyki Forum

565 Fora

63.8 K Tematy

447.5 K Posty

19 Online

69.5 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte