Prusa3D Forum

Notifications

Clear all

Csanders

Groupe: Enregistré

A(ont) rejoint: 2021/04/07

Active Member

	Great thanks, I wasn't aware of (or forgot about) that list.... Dans le forum How do I print this? (Printing help)	il y a 4 years
	As an interesting note, I ordered 2 spools of Jayo and the 2... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Update: I've taken out the PTFE tube in the extruder. An ins... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@bogdanh lol the thought has crossed my mind. I figure I'll ... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Beginner: JayoPLA doesn't print unsure how to calibrate Dans le forum How do I print this? (Printing help)	il y a 4 years
	Yes I do mean the flow factor. My understanding is that slic... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	@leem Thanks I'll look through the filament tuning to see if... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Just to extend the list of things I've tried for the recomme... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	@clarmrrsn thanks, I've read through both threads. I'm tryin... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Since I couldn't find any calibration tests that demonstrate... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	@diem Thanks, I have been successful with my own prints afte... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Finished the test at 225 and the tolerances were worse, whic... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Just an update, based on the tower I've tried printing a tol... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	@leem Thanks for the confirmation. That's how that one print... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	@turro75 Thanks for the suggestion. Any test print in partic... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Threads don't work, not sure where to start troubleshooting Dans le forum Assembly and first prints troubleshooting	il y a 5 years

Statistiques du forum

585 Forums

68.5 K Sujets

479.5 K Messages

11 En-ligne

76.7 K Membres

Le dernier des messages: Auto retraction question Notre nouveau membre: Richard Zimmerman Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé