Notifications
Clear all
crullier
Skupina: Registrovaný
Přidal se: 2020/02/09
Active Member
1
| did you ever hear back to them. I am also experiencing that ... | před 5 years | |
|
Tilt and warped mechanical prints In forum Hardware, firmware and software help |
před 5 years | |
| would you please post some images ? | před 5 years | |
|
yes need a way to check In forum Hardware, firmware and software help |
před 5 years | |
|
That sucks, I was afraid of this. I wish that maybe we didn'... In forum Hardware, firmware and software help |
před 5 years | |
| Some of the better prints I see online of mechanical parts a... | před 5 years | |
| yes there is some truth to that. The automatic supports are ... | před 5 years | |
| then maybe I need too look at a formlabs. maybe the technolo... | před 5 years | |
| oh wow dude. how is it running now? | před 5 years | |
| The question for me is how is this even accessed. I have the... | před 5 years | |
| I have the same challenge as the OP. test and calibration pr... | před 5 years | |
| YES I SECOND THIS REQUEST !!!! | před 5 years |