Notifications
Clear all
Crab
Grupa: Zarejestrowany
Dołączył: 2022/03/03
Honorable Member
1
| Can't seem to dial in my PolyTerra Blk PLA | 4 years temu | |
|
Do I need to enter Z offset into Printer Settings? In forum PrusaSlicer |
4 years temu | |
| Thanks to all that helped.. the lowered Z axis did the trick... | 4 years temu | |
| Here was the current setting (-1.100 on right) and I cleaned... | 4 years temu | |
| I have the Z at about -1.1 .. I had seen that and it appeare... | 4 years temu | |
| I did clean with 99% IPA, but I did not wash.. I will do and... | 4 years temu | |
| Noobie: Kit: Benchy spaghetti.. what do I tune? | 4 years temu |
Strona 28 / 28
Wstecz