Čeština
Fóra
Uživatelé
cpu
Aktivita
 
Notifications
Clear all
cpu
cpu
Skupina: Registrovaný
Přidal se: 2021/07/08
Active Member
1
Profile Aktivita
It's idea to use parts that laying around to build second pr...

In forum Hardware, firmware and software help

 před 3 years
MK3S Bear clone advice

In forum Hardware, firmware and software help

 před 3 years
Ok so the plan is: Dragon hotend assembled with 50W cartridg...

In forum How do I print this? (Printing help)

 před 3 years
I had to take apart hotend anyway so I did this and found th...

In forum How do I print this? (Printing help)

 před 3 years
I'll update on this matter once thermistor will arrive as du...

In forum Hardware, firmware and software help

 před 3 years
this is going to be a long road chasing issues

In forum How do I print this? (Printing help)

 před 3 years
60W heater cartridge on MK3S+?

In forum Hardware, firmware and software help

 před 3 years
I have this one printed already and on Y it's in the middle ...

In forum How do I print this? (Printing help)

 před 3 years
Cold pull was done before swapping nozzle - clean, loading f...

In forum How do I print this? (Printing help)

 před 3 years
Just a note here - been playing with X and Y belts - Y is ea...

In forum How do I print this? (Printing help)

 před 3 years
Underextrusion shows Z layer artefacts?

In forum How do I print this? (Printing help)

 před 3 years
Thanks for pointing me into right direction - it sums out th...

In forum How do I print this? (Printing help)

 před 4 years
@swiss_cheese yes top of the print. So reduced extrusion to ...

In forum How do I print this? (Printing help)

 před 4 years
PETG 0.6 nozzle print artifacts?

In forum How do I print this? (Printing help)

 před 4 years
Share: