Notifications
Clear all
Cor
Skupina: Registrovaný
Přidal se: 2018/01/29
Active Member
1
|
@ Gary.b: Yes I did about 6 Prusa logo's with PLA , just to ... In forum How do I print this? (Printing help) |
před 6 years | |
|
@ Protoncek: I have just now downloaded SLicer, but am not i... In forum How do I print this? (Printing help) |
před 6 years | |
|
This is how it suppose to come out of the printer In forum How do I print this? (Printing help) |
před 6 years | |
|
Why does this print fail. In forum How do I print this? (Printing help) |
před 6 years | |
|
Interesting.
I am using the white ABS which I ordered toget... In forum Hardware, firmware and software help |
před 6 years | |
|
Fillament sensor not working although bite says OK In forum Hardware, firmware and software help |
před 6 years | |
|
You are using Slic3r start and end gcode. It needs the varia... In forum Hardware, firmware and software help |
před 6 years | |
|
Greetings,
I Tried to setup the start en end G-code in th... In forum Hardware, firmware and software help |
před 6 years |