Notifications
Clear all
cooldude
Skupina: Registrovaný
Přidal se: 2020/05/08
Active Member
1
| @charles-h13 Which clone you would suggest? | před 6 years | |
| @holmes4did you mean stock extruder? What did it improve for... | před 6 years | |
| is bontech extruder and mossquito clone worth it for printin... | před 6 years | |
|
I think these are same as LUM8 but without the seal In forum Hardware, firmware and software help |
před 6 years | |
|
RE: Replacement bearings recommendation In forum Hardware, firmware and software help |
před 6 years | |
|
I am looking to replace bearings and rods on my new MK3s kit... In forum Hardware, firmware and software help |
před 6 years |