Notifications
Clear all
Construtor
Skupina: Registrovaný
Přidal se: 2021/04/23
Active Member
1
| Thank you for the reply. I was on live chat with Prusa for ... | před 2 years | |
| The firmware loaded is the 3.11.0-04955 Can't edit old thr... | před 2 years | |
| I have just tried with SuperSlicer and, as expected, it yiel... | před 2 years | |
| Z Adjust - Newbie | před 2 years | |
|
I have added two screen shots...one when second part is load... In forum PrusaSlicer |
před 4 years | |
|
@joantabb (this is in regards to your post from..... Posted ... In forum PrusaSlicer |
před 4 years | |
|
Answering my own question... M0; ...did the trick. In forum PrusaSlicer |
před 4 years | |
|
Print Pause not being recognized In forum PrusaSlicer |
před 4 years |