Notifications
Clear all
colemine
colemine
Group: Registered
Joined: 2024/11/26
Eminent Member
2
OOMG thank you.. I am pulling the stupid drive in and out, a...

In forum Hardware, firmware and software help

2 months ago
6.3.5 alpha firmware

In forum Hardware, firmware and software help

2 months ago
Thank you!!!

In forum Hardware, firmware and software help

2 months ago
Following... I just installed it too. I have not printed wi...

In forum Hardware, firmware and software help

2 months ago
Never mind... I was informed this is normal for the wires to...

In forum Hardware, firmware and software help

2 months ago
I see excessive wear on my belts.

In forum Hardware, firmware and software help

2 months ago
BTW... make sure you have a lot of time on your hands when y...

In forum Hardware, firmware and software help

5 months ago
Yes, I added 10 to the bed and took 10 from the head. It se...

In forum Assembly and first prints troubleshooting

6 months ago
I also experience the bad loud vibrations. I mentioned it r...

In forum Hardware, firmware and software help

6 months ago
It worked like a charm.

In forum Assembly and first prints troubleshooting

7 months ago
I am using the black galaxy prusa pla that came with the pri...

In forum Assembly and first prints troubleshooting

7 months ago
Thanks for that insight. I am trying your suggested changes...

In forum Assembly and first prints troubleshooting

7 months ago
It appears it is due to warping. The warping was so small I...

In forum Assembly and first prints troubleshooting

7 months ago
I just set up my machine today. Basically leaned in and I h...

In forum Assembly and first prints troubleshooting

7 months ago
I just opened my Prusa today. I wished they had me install ...

In forum Assembly and first prints troubleshooting

7 months ago
Top layer finish rough in some areas

In forum Assembly and first prints troubleshooting

7 months ago
thanks

In forum General discussion, announcements and releases

7 months ago
PA/Nylon build plate

In forum General discussion, announcements and releases

7 months ago
This will be my first printer with doors. I have been using...

In forum General discussion, announcements and releases

7 months ago
Thank you, so very helpful.

In forum General discussion, announcements and releases

7 months ago
Page 1 / 2
Share: