Prusa3D Forum

Notifications

Clear all

Codyyy

Group: Registered

Joined: 2021/06/05

New Member

	RE: Finally working, is my first print ok? In forum Assembly and first prints troubleshooting	3 years ago
	Finally working, is my first print ok? In forum Assembly and first prints troubleshooting	3 years ago
	If the Z height was much too high, would the filament curl u... In forum Assembly and first prints troubleshooting	3 years ago
	@nfwolfpryde I’m glad I found this post. I was following the... In forum Assembly and first prints troubleshooting	3 years ago

Forum Statistics

559 Forums

63 K Topics

443.6 K Posts

22 Online

67.9 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed