Prusa3D Forum

Notifiche

Cancella tutti

Cody

Gruppo: Registrato

Registrato: 2020/12/16

Active Member

	Just a followup after doing another print. It looks like I'm... Nel forum Hardware, firmware and software help	4 years fa
	Still haven't solved this problem. I checked the bed to see ... Nel forum Hardware, firmware and software help	4 years fa
	It's sitting on a table on anti-vibration pads. I've even tr... Nel forum Hardware, firmware and software help	4 years fa
	I checked all the screws. Frame is solid, bed is solid. Ther... Nel forum Hardware, firmware and software help	4 years fa
	Ok, pulled the y-axis rails off, cleaned, lubed them. Rotate... Nel forum Hardware, firmware and software help	4 years fa
	This can't be good... On the top of the left-side rail (the... Nel forum Hardware, firmware and software help	4 years fa
	Y-Axis problem? It's not vibrations or belt tension Nel forum Hardware, firmware and software help	4 years fa

Statistiche Forum

565 Forum

63.6 K Discussioni

446.2 K Post

20 Online

68.9 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso