Prusa3D Forum

Notifications

Clear all

Clough42

Groupe: Enregistré

A(ont) rejoint: 2023/12/06

Active Member

	Oh, interesting. That's a possibility. If I ever see the e... Dans le forum Assembly and first prints troubleshooting	il y a 11 months
	PETG in my case, so I think 85C. I have the new tile, but I... Dans le forum Assembly and first prints troubleshooting	il y a 11 months
	I did some testing, swapping heat bed cables and channels, a... Dans le forum Assembly and first prints troubleshooting	il y a 11 months
	The skipped steps are definitely unrelated. The carriage is... Dans le forum Assembly and first prints troubleshooting	il y a 11 months
	Repeated Modular Bed Error (unexpected temperature peak) at ... Dans le forum Assembly and first prints troubleshooting	il y a 11 months
	That wouldn't surprise me--especially on a printer this larg... Dans le forum Assembly and first prints troubleshooting	il y a 11 months
	This looks like what I'm seeing. Some areas of the bed are ... Dans le forum Assembly and first prints troubleshooting	il y a 11 months
	Inconsistent first layer height - Sometimes too high - Somet... Dans le forum Assembly and first prints troubleshooting	il y a 12 months

Statistiques du forum

559 Forums

63 K Sujets

443.3 K Messages

21 En-ligne

67.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé