Notifications
Clear all
CliffAgius
Skupina: Registrovaný
Přidal se: 2018/05/08
Active Member
1
|
Good advice and thanks I will use STL exports then and watch... In forum PrusaSlicer |
před 2 years | |
|
Yeah I see the idea of exporting in STL but I was exporting ... In forum PrusaSlicer |
před 2 years | |
|
Slicer adding lines to a curve In forum PrusaSlicer |
před 2 years | |
| I have the same issue with the filament not loading on slot ... | před 5 years | |
| Thanks for the reply however it's not that as the filament i... | před 5 years | |
|
I am getting exactly the same issue and I have my Filament s... In forum Hardware, firmware and software help |
před 5 years | |
| MMU Moves to select new filament with last still loaded. | před 5 years |