Notifiche
Cancella tutti
CliffAgius
Gruppo: Registrato
Registrato: 2018/05/08
Active Member
1
|
Good advice and thanks I will use STL exports then and watch... Nel forum PrusaSlicer |
2 years fa | |
|
Yeah I see the idea of exporting in STL but I was exporting ... Nel forum PrusaSlicer |
2 years fa | |
|
Slicer adding lines to a curve Nel forum PrusaSlicer |
2 years fa | |
| I have the same issue with the filament not loading on slot ... | 5 years fa | |
| Thanks for the reply however it's not that as the filament i... | 5 years fa | |
|
I am getting exactly the same issue and I have my Filament s... Nel forum Hardware, firmware and software help |
5 years fa | |
| MMU Moves to select new filament with last still loaded. | 5 years fa |