Notifications
Clear all
Classified Defense
Groupe: Enregistré
A(ont) rejoint: 2019/12/18
Active Member
1
|
I don't even have the option for 0.25MM layer height. I'm no... Dans le forum Hardware, firmware and software help |
il y a 7 months | |
|
0.4MM Nozzle - 0.3MM Layer Height Gone?! Dans le forum Hardware, firmware and software help |
il y a 7 months | |
|
Where did we all end up for this bug? It just happened to me... Dans le forum PrusaSlicer |
il y a 4 years | |
|
I did download and try to format the last card that failed w... Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
110% every single time. Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
I am going to order two new cards. They will be the 16gb car... Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
I have checked the wiring but I will check again. Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
Second SD Card Failure Dans le forum Hardware, firmware and software help |
il y a 6 years |