Notifications
Clear all
christopher.d16
christopher.d16
Group: Registered
Joined: 2018/04/23
Eminent Member
2
I'm always very careful to have all of the parts on the same...

In forum How do I print this? (Printing help)

6 years ago
Not all parts in model printing?

In forum How do I print this? (Printing help)

6 years ago
I tried holding out for the powder coated sheet but gave up....

In forum General discussion, announcements and releases

6 years ago
You might want to run through this routine to make sure your...

In forum General discussion, announcements and releases

6 years ago
I would try drying the filament and make sure you store it i...

In forum How do I print this? (Printing help)

6 years ago
That's a good idea...I'm going to give that a try. Works we...

In forum General discussion, announcements and releases

6 years ago
Hi Robin....I'm not sure I'm following you. I also use Slic...

In forum General discussion, announcements and releases

6 years ago
So far I've printed some small parts on this surface....noth...

In forum General discussion, announcements and releases

6 years ago
Yeah durability seems like it could be an issue...not sure h...

In forum General discussion, announcements and releases

6 years ago
Yes...I had to add +0.15 Z-offset to my nylon profile to get...

In forum General discussion, announcements and releases

6 years ago
Well...so far all I have had time to do is run a few test pr...

In forum General discussion, announcements and releases

6 years ago
So after a few test prints it was easy to dial in the Z-heig...

In forum General discussion, announcements and releases

6 years ago
Hi Kevin...I have the new plate and the print surface is ins...

In forum General discussion, announcements and releases

6 years ago
I use sealable pet food containers for some rolls and large ...

In forum General discussion, announcements and releases

6 years ago
Compensating for different build plate thicknesses?

In forum General discussion, announcements and releases

6 years ago
As Phil mentioned above...maybe try adjusting your live Z wi...

In forum General discussion, announcements and releases

6 years ago
Allen...thank you for the feedback. I had good success with...

In forum General discussion, announcements and releases

6 years ago
Well...I ordered the bare BuildTak plate and the new roll of...

In forum General discussion, announcements and releases

6 years ago
I've had a great experience with the MK3 also...it's a very ...

In forum General discussion, announcements and releases

6 years ago
GeckoTek EZ-Stik surface on flexplate for nylon?

In forum General discussion, announcements and releases

6 years ago
Page 1 / 2
Share: