|
Cleaning ABS juice spray sprinkler ? In forum Print tips (Archive) |
10 years ago |
|
Hi,
the LED ramp I'm using is directly wired to 220 V, it's... In forum Improvements (Archive) |
10 years ago |
|
Hi Peter,
I didn't mean to ask support to replace the board... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Hi Wig,
Probably the best thing to do should be to contact... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Thanks for the explanation Peter.
I was specifically speaki... In forum Print tips (Archive) |
10 years ago |
|
Hi
Well, now that my OctoPrint box is fully working, I must... In forum Improvements (Archive) |
10 years ago |
|
Thanks a lot Peter (again !).
Now I have a better understan... In forum Print tips (Archive) |
10 years ago |
|
gcode reference for Original Prusa i3 ? In forum Print tips (Archive) |
10 years ago |
|
I had this issue as well, until I decide to investigate unti... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Hi John,
in addition to Peter comment, maybe you should als... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Generic LED ramp holder In forum Improvements (Archive) |
10 years ago |
|
Mmmmh, looks like I found a good way, so I share it 🙂
Usin... In forum Software (Archive) |
10 years ago |
|
Hi Peter,
I just give a try to Netfab, but apparently, like... In forum Software (Archive) |
10 years ago |
|
Separate parts from STL ? In forum Software (Archive) |
10 years ago |
|
Fantastic !
thanks a lot Peter, really appreciated ! I will... In forum Print tips (Archive) |
10 years ago |
|
Kisslicer settings ? In forum Print tips (Archive) |
10 years ago |
|
Hi,
In my case, any other sd card, even without adaptor, ha... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Setting up an Octoprint box from scratch In forum Prusa i3 kit (Archive) |
10 years ago |
|
Ok, I've done the double check.
In fact I was pretty close,... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Mmmh, I think both points are related, the position of the ... In forum Prusa i3 kit (Archive) |
10 years ago |
