Notifications
Clear all
Christoph P.
Skupina: Registrovaný
Přidal se: 2022/01/06
Active Member
1
| Ich konnte das Problem lösen. Der Entscheidene Hinweis war d... | před 2 years | |
| Kollision erkannt / keine Kalibirierung möglich | před 2 years | |
| BTW: This behaviour is only with Flexfill. Not with PETG... | před 3 years | |
|
Thank you for the tip! That worked for me! Where do I find... In forum PrusaSlicer |
před 3 years | |
| "Pickles" on Filaflex prints | před 3 years | |
|
No support / too much support In forum PrusaSlicer |
před 3 years | |
|
Hi! Yes - that was the problem (it was activated). Why is it... In forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen |
před 4 years | |
|
Slicer erzeugt kein Stützmaterial In forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen |
před 4 years |