christian.ho – Activité

Notifications

Clear all

christian.ho

Groupe: Enregistré

A(ont) rejoint: 2020/06/17

Trusted Member

	For reference, it really looks like that top center boat is ... Dans le forum How do I print this? (Printing help)	il y a 4 years
	I attached my wall of shame... Usually the print fails after... Dans le forum How do I print this? (Printing help)	il y a 4 years
	I switched the z offset presets when switching the sheets. A... Dans le forum How do I print this? (Printing help)	il y a 4 years
	TPE won't stick to Printbed... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Optimal Tension on the Filament? Dans le forum User mods - OctoPrint, enclosures, nozzles, ...	il y a 4 years
	Thanks! Tried it, works just as you described! (The slicing ... Dans le forum Hardware, firmware and software help	il y a 4 years
	Different part - same issue. I wanted to print foots for a b... Dans le forum Hardware, firmware and software help	il y a 4 years
	Oh, really a bummer that it is open so long already 🙁 The... Dans le forum Hardware, firmware and software help	il y a 4 years
	Hi Joan, Yes, there is a shape above. If I enable all laye... Dans le forum Hardware, firmware and software help	il y a 4 years
	Slicer starts Bridging in Midair Dans le forum Hardware, firmware and software help	il y a 4 years
	Oh no, I think a long reply that I wrote got lost.... Anyw... Dans le forum Hardware, firmware and software help	il y a 4 years
	Strong oozing and stringing, already decreased temperature Dans le forum Hardware, firmware and software help	il y a 4 years

Page 3 / 3 Précédent

Statistiques du forum

559 Forums

62.8 K Sujets

442.5 K Messages

22 En-ligne

67.4 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé