Čeština
Fóra
Uživatelé
chrischin
Aktivita
 
Notifications
Clear all
chrischin
chrischin
Skupina: Registrovaný
Přidal se: 2018/12/15
Trusted Member
3
Profile Aktivita
Corner gaps help

In forum How do I print this? (Printing help)

 před 5 years
The first rectilinear infill layer will have an extra wide l...

In forum How do I print this? (Printing help)

 před 5 years
Why do you prefer it over grid? Seems like they're the same ...

In forum How do I print this? (Printing help)

 před 5 years
Oh wow. I had no idea rectilinear behaved this way. At one...

In forum How do I print this? (Printing help)

 před 5 years
These gaps circled in red. Shouldn't the infill be a solid ...

In forum How do I print this? (Printing help)

 před 5 years
Stringy Infill

In forum How do I print this? (Printing help)

 před 5 years
Just found it! Disabling the "Layers and perimeters" settin...

In forum Hardware, firmware and software help

 před 6 years
There is an angle every so slightly less than 90 degrees on ...

In forum Hardware, firmware and software help

 před 6 years
Slic3r infill help

In forum Hardware, firmware and software help

 před 6 years
Thanks so much! Worked like a charm.

In forum Hardware, firmware and software help

 před 6 years
Thanks Mark. This is cold, PLA setting. Definitely conside...

In forum Assembly and first prints troubleshooting

 před 6 years
Yes this There are two "this". Which one?

In forum Hardware, firmware and software help

 před 6 years
Which example lol?

In forum Hardware, firmware and software help

 před 6 years
config.h file lang mode

In forum Hardware, firmware and software help

 před 6 years
Bed leveling help

In forum Assembly and first prints troubleshooting

 před 6 years
Stránka 3 / 3
Share: